TABLE OF CONTENTS
- Turbo Mesh Kit, Blaze Kit, Debut Kit, E-Drum Total, DM Lite Kit
- Nitro Mesh Kit, Surge Mesh Kit, Nitro Kit.
- Nitro Max and Nitro Pro Kits
- Command Mesh, Command X Mesh, Command X, Command Kit, Crimson Mesh Kit, Crimson II Kit
- DM10 MKII Pro and DM10 MKII Studio
- Strike SE, Strike Pro, Strike Kit
- Strata Prime and Strata Core Kits
- Continued support:
Turbo Mesh Kit, Blaze Kit, Debut Kit, E-Drum Total, DM Lite Kit
Hold down the - and + buttons while powering on. If the reset is successful, you will see "FAC" briefly appear on the display.
Nitro Mesh Kit, Surge Mesh Kit, Nitro Kit.
Hold down the < and > buttons while powering on. If the reset is successful, you will see "RST---" appear on the screen.
Nitro Max and Nitro Pro Kits
Hold down the - and + buttons while powering on. If the reset is successful, you will see "RST---" appear on the screen.
Command Mesh, Command X Mesh, Command X, Command Kit, Crimson Mesh Kit, Crimson II Kit
Press and Hold the < and > buttons while powering on. You will then see " Erasing all content..." followed by "Reset OK!"
Crimson III Kit
-Press the Menu button from your main Kit screen.
-Press the Down arrow until you reach Factory Reset, then press F3(labeled on screen as Enter) to select.
-Use the Up and Down arrows to navigate which reset you would like to take place.
• Kit: Resets only the user kit settings.
• Song: Resets only the user songs.
• Voice: Resets only the user voices.
• Trigger: Resets only the user trigger settings.
• All: Resets all user settings.
-Press the F3 button to select the reset you have highlighted.
NOTE: Please do not power down the module during this process. If it should happen by accident, please repeat the process and reset the module again, as the incomplete factory reset module may not function properly.
DM10 MKII Pro and DM10 MKII Studio
- Press the Utility Button
- Use the Down and Up buttons to select from the options
below. Find the Factory Set
- Press F1 to enter
- Menu option will do the following:
• Kit: Resets only the user kit settings.
• Song: Resets only the user songs.
• Voice: Resets only the user voices.
• Trigger: Resets only the user trigger settings.
• All: Resets all user settings.
**If for any reason you are unable to perform a reset via the utility settings:
1. Power on the unit while holding the two arrow buttons
2. Select Menu > Factory Reset > Reset all
Strike SE, Strike Pro, Strike Kit
- Press and hold the Stop and Enter buttons while powering up the module. "Resetting Factory Defaults..." will be displayed on the module.
- Wait 5 seconds, then let go of the buttons.
Strata Prime and Strata Core Kits
Go to Settings > Info tab > Factory Reset.
Note: This will remove your user kits and leave you with the factory installed kits.
Continued support:
https://inmusicsupport.freshdesk.com/en/support/solutions/69000433150
https://www.youtube.com/watch?v=dZWWibAoaLg